There is a lot more to designing flitch beams than just the member calcs. There is bolting both for the intermediate spacing and the ends and special bearing checks etc. This Design is likely best left to other paid for design programs. I am not plugging them, but I do use EnerCalc's Flitch Beam module and it works pretty well.
This would be great; I hope they would add flitch beam. they can take a look to TEDDS and Cleacalcs to add that. It would be great and it would give us 100% fully report from FORTE
Guest
There is a lot more to designing flitch beams than just the member calcs. There is bolting both for the intermediate spacing and the ends and special bearing checks etc. This Design is likely best left to other paid for design programs. I am not plugging them, but I do use EnerCalc's Flitch Beam module and it works pretty well.
Use the same principles used in Strucalc to design flitch beams
This would be great; I hope they would add flitch beam. they can take a look to TEDDS and Cleacalcs to add that. It would be great and it would give us 100% fully report from FORTE