Forte Software Ideas

When designing wall columns the only lateral connector option for Mitek is the AC3 but I would like to have more options such as MP5, MP7 or MPA1. If I use Simpson I usually get 3 options. Not sure why only one option appears for Mitek

For example, you model a lintel for a typical floor throughout a multistorey building. This lintel is consistent down to the main floor, where it hits a transfer beam. Instead of linking the load X amount of times, you could just specify how many ...

Forte provides for most common Steel beam sizes. But I deal with both loads on existing structures & needing beams beyond those now in Forte: 5", 6", & 7" I-beams HSS square & rectangular Existing A36 beams, particularly during remodels

It would be a huge time saver to be able to see reactions next to the member design in the Job Summary tab. Having the Results and Current Solution listed there for all members in a project is very helpful, but having to click each individual memb...

Would be useful when trying to compare the effect of adding point loads from a post on how it affects the design.

Now that Microllam has code approval for wall memebers, I've had an increase in requests to design in ForteWeb. In the southeast 2x8 TimberStand is only stocked 20' lengths. Taller walls have few options and Microllam is a good fit for strength an...

As the primary function of Ceiling Joists is to resist tension in conventionally-framed roof systems, Attic joist member types should consider such forces in their analysis.

It would be great to see the design values for the hangers next to the hanger that is selected. It is a bit of a black box when it shows the different types of hangers that can be used.

Would be nice to be able to check timber designs and not have to switch programs or perform the design by hand.

Would be useful if we could use pressure treated southern pine lumber as a solution option