Forte Software Ideas

Since Last few weeks while switching tabs & specially switching tabs on solution & report it take too much time to show results & many of the time it stuck over there & need to refresh web page to go back,

Add a dark mode feature

I'd like the ability to enter a deflection limit in inches (not L/xxx) on the Member Info tab.

Separate loads by some visual difference in visual diagram. Be able to tell at a glance what kind of loads are bearing on that beam instead of a solid blue block. Helpful for anyone double checking what kind of loads are used on beam. Possibly tie...

There's an option for French, please add Spanish.

I can't even design a select structural floor joist in commodity lumber? Inconceivable!

Why wouldn't we want to know the nail patterns by default?

Would like a tapered psf input for hip beams that might have drift snow load on it. Currently the module only allows for a uniform loading on a Hip/Valley.

Why is the trib width field at the top of the Loads screen for wall columns rather than down below with other info? It is really easy to forget to fill out this field since it sits above the Eccentricity area, and not with the actual loading crite...

While it is possible to model a multi-ply header in standard orientation, header models still only allow for 1-ply design when considering lateral wind loads. Typically wind design (with bi-axial loading) has to be considered for headers, especial...